Torque Driver for ET

Description

Description

• Driver for torque wrench
• Tip holding function
• May bend or break if excessive torque is applied
• Damage is possible even at low torque if not fully engaged
• Apply vertical pressure when applying toque (do not tilt)
• If the tip is bent or stripped, replace immediately

View AllClose

Locator Torque Driver

• Torque driver for Locator Abutments

Torque Driver Handle

• Used for initial insertion by hand after fastening to torque driver

Repair Torque Driver

• Reduced diameter of shank compared to the Torque Driver (Ø2.1 → 1.6)• The diameter of the screw hole can be minimized during prosthetic repair or SCRP procedures

Angled Torque Driver

• Driver for torque wrench• No holding function• Recommended tightening torque: 30Ncm (excessive torque causes fracture)• Do not remove tube to prevent fragmentation when broken• Recommended number...

Torque Driver for Denture Type

• Driver for EM(MS) implants: denture• The triangular marking is used in line with the implant

OneMS Fixture Driver for ET

• Used with the torque wrench for adjustment of the final implant placement• Yellow grooves align with abutment hex direction• Match the groove of OneGuide template with the groove of driver

Torque Driver for Narrow Ridge & Provisional Type

• Driver for EM(MS) implants: narrow ridge & provisional• The triangular marking is used in line with the implant

Torque Wrench

• Tightens Screw Driver and removes the fixture using the Remover Body• Applies up to 400Ncm of torque (markers at 80/100/200/300/400Ncm)• Torque by pulling the bar back until it reaches the desired...

Torque Driver for ET

Description

Related Products