OneCAS Ø2.2 Twist Drill for F5.0(w)

• Recommended to drill 1mm under the lower margin of maxillary sinus• For use with a stopper for safe membrane approach• 1mm shorter than the twist drill in the Taper Kit

• Use with the guide of OneCAS system• The membrane is safely lifted during maxillary sinus surgery• Possible to collect autogenous bone at low rpm?s• For use with a stopper for safe membrane...

• Stopper number is total length when engaged• When the 7mm CAS drill is used, the protruding length is indicated in blue on the OneCAS kit.• When 10mm drill is used, the protruding length is...

• Recommend to under-drill by 1mm below the floor of the sinus• Use with stoppers for safe and controlled drilling• Apex tip measures an additional 0.6mm

• Used with Ø5.8 guide• Taper drill design optimized for Type III/IV fixtures• Multi-step drill design allows for stable drilling

• Drills the hole in the stone model for the guide pin• Number of usages: 10 times• Drill after marketing the site with the round bur• Recommended speed: 1,200 ~ 1,500rpm

• Used with Ø5.8 guide• Taper drill design optimized for Type III/IV fixtures• Multi-step drill design allows for stable drilling

• Used with Ø5.8 guide• Taper drill design optimized for Type III/IV fixtures• Multi-step drill design allows for stable drilling

• Used with Ø5.8 guide• Taper drill design optimized for Type III/IV fixtures• Multi-step drill design allows for stable drilling