Depth Gauge for F4.0/4.5

Description

Description

• Stopper number is total length when engaged
• When the 7mm CAS drill is used, the protruding length is indicated in blue on the OneCAS kit.
• When 10mm drill is used, the protruding length is indicated in red
• Color coded by length
• Recommended number of use: 50 times

View AllClose

OneCAS Stopper for F4.0/4.5

• Stopper number is total length when engaged• When the 7mm CAS drill is used, the protruding length is indicated in blue on the OneCAS kit.• When 10mm drill is used, the protruding length is...

OneCAS Drill for F4.0/4.5

• Use with the guide of OneCAS system• The membrane is safely lifted during maxillary sinus surgery• Possible to collect autogenous bone at low rpm?s• For use with a stopper for safe membrane...

OneCAS Ø2.2 Twist Drill for F4.0/4.5

• Recommended to drill 1mm under the lower margin of maxillary sinus• For use with a stopper for safe membrane approach• 1mm shorter than the twist drill in the Taper Kit

Depth Gauge

• Release a wedged Expansion drill stuck inside the bone on the way out• Use with an open wrench to turn the hex of the Expansion drill• Prevents from over torquing

Depth Gauge for F5.0

• Check if access is gained to the maxillary sinus• Gauge height of residual bone• For use with a stopper for safe membrane approach• Same depth marking lines as on a 10mm drill

Depth Gauge for CAS Kit

• Checks for access into the sinus cavity and measures the thickness of residual bone

Depth Gauge for ESSET Kit

• Release a wedged Expansion drill stuck inside the bone on the way out• Use with an open wrench to turn the hex of the Expansion drill• Prevents from over torquing

OneGuide Drill F4.0 for Below F5.0

• Used with Ø5.0 guide• Taper drill design optimized for Type III/IV fixtures• Multi-step drill design allows for stable drilling• F4.5 cortical drill needed for F4.5 placement in hard bone

Depth Gauge for EM(MS) Kit

• Left: to check the drilled depth• Right: to bend the neck of the EM (MS) provisional type• MS narrow narrow ridge type cannot be bent

Depth Gauge for F4.0/4.5

Description

Related Products